Instructions

Things you’ll need:

·                       Particle Board to match the height of the floor outside bathroom

·                       Drill (battery or electric)

·                       Phillips Bit holder

·                       Phillips Bit

·                       Fix all

·                       Linoleum Tiles

·                       Sharp Knife

·                       Tape Measure

·                       Chalk Line

·                       Marker

·                       Sander or Sanding Block

·                       Trowel

·                       Mixing Bucket

·                       Water

        Step 1

Remove all of your existing flooring down to the floor boards or concrete

Step 2

Rip out any cabinets you don’t want

Step 3

Lay down your underlayment (I used 3/8″) Screw it down around the perimeter every 4″ and on the inside every 8″

       Step 4

Cut around your outflow

       Step 5

Make sure you countersink your screws

      Step 6

Cover floor with fixall and sand as smooth as possible

      Step 7

Vacuum the floor, and then wipe down floor with a damp cloth to get all the dust out

 Step 8

Lay your tiles starting at the exact center of the room

         Step 9

Take your time cutting out detailed corners

          Step 10

I like to save the hard parts for last, like this cutout I’ve been putting off…

         Step 11

Once the entire tile is laid, all you have to do is put the trim back up

          Step 12

Clean floor with dry cloth before reinstalling sink/toilet and anything else